# GARGOS DUNGEON INTRO
## IKEMEN GO 1.0.0 — Installation Guide

**Stage Author:** OldGamer  
**Engine:** IKEMEN GO 1.0.0  
**Feature:** Cinematic camera zoom introduction

Welcome! This guide will help you install the Gargos Dungeon stage and its cinematic camera introduction.

Please follow each step in order.

### STEP 1 — Back Up Your Game

Before installing, I recommend making a backup copy of your IKEMEN GO folder.

That way, if anything goes wrong, your original game remains safe.

### STEP 2 — Extract the Download

1. Download the Gargos Dungeon Intro ZIP file.
2. Extract the ZIP using Windows, WinRAR, or 7-Zip.
3. Open the extracted folder.

You should see two folders:

- `data`
- `stages`

Copy both folders.

Now open your main IKEMEN GO folder, where `Ikemen_GO.exe` is located.

Paste both folders there.

If Windows asks to merge folders, allow it. Keep your existing game files.

**Important:** Copy the contents into the main game folder, not inside another `data` or `stages` folder.

### STEP 3 — Enable the Cinematic Script

1. Open your IKEMEN GO folder.
2. Open the `save` folder.
3. Find `config.ini`.
4. Open that file using Notepad or Notepad++.
5. Find the section called `[Common]`.
6. Look for the line beginning with `States =`.

At the very end of that existing line, add:

` , data/dungeon-intro.zss`

The actual entry should have one comma separating it from the previous file.

**Important:** Do not erase any existing entries on the States line.

When finished, press **Ctrl + S** to save.


### STEP 4 — Add the Gargos Dungeon Stage

1. Open your main IKEMEN GO folder.
2. Open the `data` folder.
3. Find `select.def`.
4. Open it with Notepad or Notepad++.
5. Locate the `[ExtraStages]` section.
6. On a new line, add exactly:

`stages/DungeonIntro/Dungeon.def`

Press **Ctrl + S** to save.

The Gargos Dungeon stage is now registered in your stage list.

### STEP 5 — Launch IKEMEN GO

1. Start IKEMEN GO normally.
2. Select **Versus Mode**.
3. Choose your two fighters.
4. Select the **Gargos Dungeon** stage.
5. Start the match.

### STEP 7 — Enjoy the Cinematic Introduction!

When round one begins, the camera should perform its special cinematic zoom before the fight starts.

The effect automatically uses the fighters you selected.

You do not need to enter special commands or press any buttons to activate it.

**The cinematic is designed to play during Round 1.**

### TROUBLESHOOTING

**The stage loads, but the camera doesn't zoom.**

Check the following:

- The file `data/dungeon-intro.zss` is installed.
- The script is listed under `States` in `save/config.ini`.
- `ZoomActive = 1` is enabled in `save/config.ini`.
- You're playing Round 1 on the correct Gargos Dungeon stage.
- You're using the updated `dungeon-intro.zss` included in the release.

**The stage doesn't appear in the stage selection.**

Check that this file exists:

`stages/DungeonIntro/Dungeon.def`

Also verify that the same path was added to `data/select.def`.

### FINAL NOTES

This release is intended for **IKEMEN GO 1.0.0**.

The stage files load the Gargos Dungeon arena, while the shared ZSS script controls the special cinematic camera.

The demonstration uses the standard IKEMEN GO announcer and the current bridge model.

Enjoy the stage, and have fun!

**— OldGamer**
